Using Registration Memory 
To recall registration memory bank data from a file
1. Depending on where the file is located, perform one of the steps shown below.
If the file is located | Perform this operation: | |
here: | ||
| ||
Internal area | Remove the SD card from the | |
| Digital Piano’s card slot. | |
|
| |
SD card | Insert the SD card into the Digital | |
| Piano’s card slot. | |
|
|
2. Press the (REGISTRATION) button so the lamp below it is lit. This is the REGISTRATION mode.
3. If you are recalling a file that contains data for
asingle bank, use the (w, q) buttons to scroll through the bank numbers (1 through 8) until the one to which you want to recall the data is displayed.
•If you are recalling a file that contains data for all banks, you can skip this step.
4.While holding down the (FUNCTION) button, press the (LOAD/SAVE) button.
•This enters the LOAD/SAVE mode.
5.Depending on the type of operation you want to perform, use the (u) and (i) buttons to display one of the screens shown
below.
To recall a file that contains data for a single bank
To recall a file that contains data for all banks
6. Use the (w, q) buttons to display the file that contains the data you want to recall, and then press the (ENTER) button.
•This will cause the message “Replace?” to appear.
•To cancel the recall operation and exit the LOAD/ SAVE mode, press the (EXIT) button.
7. To replace the registration data currently in the bank(s) you selected with the registration data in the file, press the (YES) button. To return to the screen in step 6 of this procedure without recalling anything, press the (NO) button.
•Pressing the (YES) button recalls the data from the file into the bank(s) and exits the LOAD/SAVE mode.
English