Confirming Common Parameter Settings 
To change common parameter settings
1. Check to make sure that the lamp above the
(MASTER CONTROL) button is lit.
•If it is unlit, press the (MASTER CONTROL) button to light it.
Lit
2. Check to make sure that the lamp above the
(ZONE EDIT) button is unlit.
•If the lamp is lit, hold down the (ZONE EDIT) button until it goes out.
3.Use the (PAGE) button to display the common menu page that contains the parameter whose setting you want to change.
Example: Common menu page 2
•Each press of the (PAGE) button advances to the next page.
4.Press the PARAMETER SELECTOR button ( (A) through (D)) to select the parameter whose setting you want to change.
•The brackets around the setting of parameter you
select will change from [ ] to %. This indicates that editing of the setting is enabled.
Example: After the (C) button is pressed
5. Use the (EDIT w, q) buttons to change the setting.
•Pressing w and q at the same time returns the setting to its initial default.
•Holding down w or q will scroll through the settings at high speed.
•For details about the meaning and range of each parameter setting, see “Common Parameter Settings” (page
6.If you want to change the settings of other parameters, repeat steps 3 through 5 of this procedure.
IMPORTANT!
Turning off the Digital Piano causes all common parameters to return to their initial default settings. If you need to save a common parameter setup, perform one of the operations described below.
•If you want to restore the current setup the next time you turn on the Digital Piano, perform the backup operation. For details, see “Backup” (page
•If you don’t need to restore the current setup the next time you turn on the Digital Piano but want to have it on hand for recall when you need it, save the setup to registration memory. For details, see “Using Registration Memory” (page
English
•Holding down one of the PARAMETER SELECTOR buttons will display its full name. For example, “LoMdG” will change to “LowMid Gain”.