Part Names and Functions

Terminals and Connectors

=

SERIAL PORT IN TERMINAL

If you control the projector by computer, you must connect a cable (not supplied) from your computer to this terminal.

SERIAL PORT OUT TERMINAL

This terminal outputs signal from SERIAL PORT IN. More than two projectors can be controlled with one computer by connecting SERIAL PORT IN of another projector to this terminal.

USB CONNECTOR (Series B)

USB connector is to used to service the projector.

R/C JACK

When using the wired remote control, connect the wired remote control to this jack with a remote control cable (not supplied).

;RESET button

!!BUILTIN MICRO PROCESSOR WHICHHCONTROLS THISOUNIT MAYY OCCASIONALLY MALFUNCTION AND NEEDFTO BECRESET 4HISICAN BE DONE BYYPRESSING THE 2%3%44BUTTONOWITH A PEN HWHICHHWILL SHUTLDOWN ANDNRESTARTRTHE UNITE $OUNOTIUSETHE 2%3%44FUNCTION EXCESSIVELY

DVI INPUT TERMINAL

Connect computer output (Digital/DVI-D type) to this terminal. (p.20)

HD (HDCP Compatible) signal can be also connected. (p.21)

D-sub 15-PIN INPUT TERMINAL

Connect computer output (Analog D-sub 15-pin type) to this terminal. (pp.20-21)

5 BNC INPUT JACKS

Connect the component or composite video output signal from video equipment to VIDEO/Y, Pb/Cb, and Pr/Cr jacks or connect the computer output signal (5 BNC Type [Green, Blue, Red, Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V jacks. (pp.20–21)

S-VIDEO INPUT JACK

Connect the S-VIDEO output signal from video equipment to this jack (p.21).

LX1000 User Manual

11

020-000141-01 Rev. 1 (05-2009)

 

Page 13
Image 13
Christie Digital Systems 020-000141-01 user manual Terminals and Connectors, USB Connector Series B, Reset button