Maintenance and Care
Lamp Replacement
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and LAMP 1/2 REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP 1/2 REPLACE indicators should light is depending on the lamp mode.
Indicators
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER.
Lamp replacement icon
Allow the projector to cool, for at least 45 minutes before you open Lamp Cover. The inside of the projector can become very hot.
LAMP 1 / 2 REPLACE indicators
CAUTION
Note:
s4HE ,AMP,REPLACEMENTEICON WILLENOTEAPPEAR WHEN THE $ISPLAYYFUNCTION ISTSETOTO h/FFvvP OR DURINGUh&REEZEvvP
Follow these steps to replace the lamp.
For continued safety, replace with a lamp assembly of the same type.
Do not drop the lamp assembly or touch a glass bulb! The glass can shatter and may cause injury.
1Check the number of lamp to be replaced on the Lamp Status Display.
2Turn off the projector, press the Main On/Off Switch to Off and unplug the AC power cord from the AC outlet. Let the projector cool for at least 45 minutes.
3Loosen a screw on the Lamp Cover. Slide and open the Lamp Cover until it makes a clicking sound. (See the right figure.)
4Loosen two screws and pull out the Lamp to be replaced by grasping handle.
5Replace the Lamp with a new one and tighten two screws. Make sure the Lamp is set properly.
6Put the Lamp Cover back and tighten a screw.
7Connect the AC Power Cord to the projector and turn on the projector.
8Reset the Lamp Replacement Counter. (Refer to section "Resetting the Lamp Counter" on page 62.)
NOTE : Do not reset LAMP REPLACEMENT COUNTER when lamp is not replaced.
LAMP |
|
COVER | SCREW |
| LAMP 2 |
SCREWS
LAMP 1
Make sure which number of lamp needs to be replaced on Lamp Status Display.
Figure shows case of replacing LAMP 1.
CAUTION : DO NOT OPERATE THE PROJECTOR WHILE ANY OF LAMPS IS REMOVED. IT MAY RESULT IN MALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTS.
NOTES ON LAMP REPLACEMENT
To maintain quality of picture (better balance of color and brightness in entire screen), we recommend replacing both 2 lamps at a time.
LX1000 User Manual | 61 |
|
