Part Names and Functions
Remote Control Battery Installation
Open the battery
1compartment lid.
Pull up the lid and remove it.
2 | Install new batteries into | 3 | Replace the |
the compartment. | compartment lid. | ||
| Two AA size batteries |
|
|
| For correct polarity (+ and |
|
|
| be sure battery terminals are |
|
|
| in contact with pins in the |
|
|
| compartment. |
|
|
To ensure safe operation, please observe the following precautions :
LUse two (2) AA or LR6 type alkaline batteries.
LAlways replace batteries in sets.
LDo not use a new battery with a used battery.
LAvoid contact with water or liquid.
LDo not expose the remote control to moisture or heat.
LDo not drop the remote control.
LIf the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
LRisk of an explosion if battery is replaced by an incorrect type.
LDispose of used batteries according to the instructions.
Remote Control Receivers and Operating Range
Point the remote control toward the projector (to Infrared Remote Receivers) when pressing the buttons. Maximum operating range for the remote control is about 16.4’ (5 m) and 60 degrees in front and rear of the projector.
Infrared Remote Receivers are provided both in front and back of the projector. You can conveniently use both of the receivers.(pp. 10, 52)
Note:
ssHEN HANGINGG THEH PROJECTORE FROM THEH CEILING SELECT THEH )NFRARED 2EMOTEO 2ECEIVER WHICHH IS LOCATEDA FARTHER AWAY FROM THE FLUORESCENT LIGHTP
16.4’ (5 m)
16.4’ (5 m)
Wired Remote Control
The remote control can be used as a wired remote control. Wired remote control helps you use the remote control outside of the operating range (16.4’/ 5 m). Connect the remote control and the projector with the remote control cable (sold separately). Connected with the remote control cable, the remote control does not emit wireless signal.
LX1000 User Manual | 15 |
|
