Basic Operation
Turning On the Projector
1Complete peripheral connections (with a computer, VCR, etc.) before turning on the projector.
2Connect the projector’s AC power cord into an AC outlet. The LAMP indicator lights red and the POWER indicator lights green.
3Press the
4After the countdown, the input source that was selected the last time and the Lamp control status icon (see page 55) appear on the screen.
If the projector is locked with a PIN code, PIN code input dialog box will appear.
Note:
•When the Logo select function is set to Off, the logo will not be shown on the screen (p.52).
•When Countdown off or Off is selected in the Display function, the countdown will not be shown on the screen (p.52).
•When the Input button function is set to Mode 3, the input signal will be searched automatically (p.51).
•If you press the
16
The preparation display will disappear after 30 seconds.
Selected Input Source and Lamp control
Input 1
RGB(PC analog)
Lamp control status
(See page 55 for Lamp control status.)
Note:
•The Lamp replacement icon and the Filter replacement or the Filter cartridge replacement icon may appear on the screen depending on the usage state of the projector.
•When the filter cartridge replacement icon keeps appearing on the screen at turning on the projector for some time and no action is taken to replace the filter cartridge, the projector will be automatically shut down in 3 minutes after turning on to protect the projector. (pp.
Enter a PIN code
Use the Point ▲▼ buttons on the side control or Number buttons on the remote control to enter a number.
When using side control
Use the Point ▲▼ buttons on the side control to select a number. Press the Point ► button to fix the number and move the red frame pointer to the next box. The number changes to . Repeat this step to complete entering a
When using remote control
Press the Number buttons on the remote control to enter a number (p.14). When you complete entering a
If you fixed an incorrect number, use the Point ◄ button to move the pointer to the number you want to correct, and then enter the correct number.
If you entered an incorrect PIN code, “PIN code” and the number () will turn red for a moment. Enter the correct PIN code all over again.
PIN Code Input Dialog Box
After the OK icon disappears, you can operate the projector.
Note:
•If the PIN code number is not entered within three minutes after the PIN code dialog box appeared, the projector will be turned off automatically.
•The "1234" is set as the initial PIN code at the factory.
LX505/LX605 User Manual | 23 |
