Maintenance and Care
Lamp Replacement
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE indicator should light is depending on the lamp mode.
Lamp cover
Top Panel
Lamp replacement icon
Screw
LAMP REPLACE indicator
Note:
The Lamp replacement icon will not appear when the Display function is set to Off (p.52) or during “Freeze” (p.30)
Follow these steps to replace the lamp.
1 | Turn off the projector and unplug the AC power cord. Let the |
projector cool for at least 45 minutes. |
2Loosen the screw and open the lamp cover. Loosen 3 screws of the lamp and pull out the lamp by using the built in handle.
3Replace the lamp with a new one. Make sure that the lamp is properly and fully inserted.
4 | Close the lamp cover and secure the screw. |
|
5 | Connect the AC power cord to the projector and turn on the |
|
projector. |
| |
| Note: | Lamp |
| Be sure to insert the lamp in the correct direction. |
|
Screws
Handle
CAUTION
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken.
If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately.
New Lamp
CAUTION 
CAUTION
Allow a projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.
For continued safety, replace with a lamp of the same type. Do not drop the lamp or touch the glass bulb! The glass can shatter and may cause injury.
66 | LX505/LX605 User Manual |
