Removing the Safety Cover | Cisco Systems 10008 instruction

Figure 12 Removing the Safety Cover

30023

Step 2 Loosen the captive screw on the rear safety cover and tilt the cover back to lift it up and out from the chassis.

Figure 13 Stripping Insulation

10 mm max

14747

Step 3 Using a wire-stripping tool, strip not more than 0.4 inches (10 mm) of insulation off the ends of the DC power leads.

21

Image 21

Cisco Systems 10008 quick start Removing the Safety Cover

Contents

Cisco 10008 Router Document Version History Documentation and ResourcesDocumentation Survey Related Documentation Obtaining Documentation Documentation Feedback Product Documentation DVDOrdering Documentation Reporting Security Problems in Cisco Products Cisco Product Security OverviewObtaining Technical Assistance Submitting a Service Request Definitions of Service Request SeverityCisco Technical Support & Documentation Website Obtaining Additional Publications and Information Site Preparation Preparing for InstallationRecommended Tools and Supplies Quantity Description Comments Installing the Router Lifting the Chassis Lifting the Chassis Rack-Mounting the Router in a 19-Inch 4-Post Rack Power Fault Miswire 30012 Attaches the chassis to the rack Step Aution Rack-Mounting the Router in a 23-Inch 2-Post Rack 30014 30015 Attaching the Cable-Management Bracket Attaching the Cable-Management Bracket Attaching the Grounding Lug Attaching Grounding Wire to Grounding Lug Suitable grounding is available. Statement Installing Line Cards Connecting Power Connecting DC Power to the Cisco 10008 RouterOr weld the metal object to the terminals. Statement Set the DC PEM switches to the Off position Removing the Safety Cover DC Power Connections Securing DC Power Cables to the Chassis Connecting AC Power to the Cisco 10008 Router Setting AC PEM Switches to the Off Position AC Power Cord Connectors in Strain-Relief Devices Connecting Alarm Indicators Connecting Cables Removing the Safety Cover Alarm Indicator Terminal Block Connections Alarm Indicator Wires Exiting the Safety Cover Connecting a Video Terminal to the PRE Console Port Console Port Connection on the PRE Ethernet Network Management Cable Connections Connecting Network Management and Signal System Cables Connecting to a 100BASE-T Ethernet Network Correctly connected to the 100BASE-T Ethernet LAN Auxiliary Modem Connection Installing Network Cables to the Line Cards Power Fault Miswire Powering On the System Configuring the Cisco 10008 Router at Startup Basic Configuration Using the Setup FacilityStartup Display Basic System Configuration Procedure Using the System Configuration Dialog Specify the IP address Routerconfig # interface FastEthernet0/0/0 Basic Configuration in Global Configuration Mode Router# format disk0 Formatting Flash Disks and Flash Cards Managing the File Systems File SystemsCLI Name Description Managing Configuration Files Larger than Nvram Compressing the Configuration FileRelocating the Configuration to a Flash Disk Exit global configuration mode Troubleshooting Installation Problems General Troubleshooting TipsSymptom Steps to Take Switch configure terminal Troubleshooting Ethernet Connections Troubleshooting the Console Port Serial Connection Page USA