Cisco Systems 10008

Step17 After you complete the configuration dialog, enter global configuration mode and enable IP routing by entering the

ip routing command:

Router(config)# ip routing

Basic Configuration in Global Configuration Mode

The following command sequence allows you to perform a configuration similar to that generated by the setup command:

Router> configure terminal

Router(config) # hostname c10008

Router(config) # enable secret my_router

Router(config) # enable password my_rtr

Router(config) # snmp-server community public

Router(config) # ip routing

Router(config) # interface FastEthernet0/0/0

Router(config-if) # no shutdown

Router(config-if) # media-type 100BaseX

Router(config-if) # half-duplex

Router(config-if) # ip address 3.5.3.45 255.255.0.0

Router # copy running-config startup-config

You can now configure the line cards. For specific information on system and interface configuration, see the Cisco10000 Series

Router Line Card Configuration Guide.