Connecting Cables | Cisco Systems 10008 instruction

5Connecting Cables

This section provides information about connecting cables to the Cisco 10008 router.

Connecting Alarm Indicators

The Cisco 10008 router provides relay contacts for optional (customer-supplied) audible or visual alarm indicators. Relay contacts are provided for three levels of severity:

•Minor—An informational alarm that does not affect system operation.

•Major—An alarm condition that affects system operation and should be investigated as soon as possible.

•Critical—An alarm condition that affects system operation and requires immediate attention.

Figure 18 Loosening Captive Screws on the Safety Cover

30022

Use the following procedure to connect an alarm indicator to the system:

Step 1 Loosen the captive screw on the rear safety cover and tilt the cover back.

26

Image 26

Cisco Systems 10008 quick start Connecting Cables, Connecting Alarm Indicators

Contents

Cisco 10008 Router Documentation Survey Related Documentation Documentation and ResourcesDocument Version History Obtaining Documentation Ordering Documentation Documentation FeedbackProduct Documentation DVD Obtaining Technical Assistance Reporting Security Problems in Cisco ProductsCisco Product Security Overview Cisco Technical Support & Documentation Website Submitting a Service RequestDefinitions of Service Request Severity Obtaining Additional Publications and Information Recommended Tools and Supplies Preparing for InstallationSite Preparation Quantity Description Comments Installing the Router Lifting the Chassis Lifting the Chassis Power Fault Miswire Rack-Mounting the Router in a 19-Inch 4-Post Rack 30012 Step Attaches the chassis to the rack Rack-Mounting the Router in a 23-Inch 2-Post Rack Aution 30014 30015 Attaching the Cable-Management Bracket Attaching the Cable-Management Bracket Attaching Grounding Wire to Grounding Lug Attaching the Grounding Lug Installing Line Cards Suitable grounding is available. Statement Or weld the metal object to the terminals. Statement Connecting PowerConnecting DC Power to the Cisco 10008 Router Set the DC PEM switches to the Off position Removing the Safety Cover DC Power Connections Connecting AC Power to the Cisco 10008 Router Securing DC Power Cables to the Chassis Setting AC PEM Switches to the Off Position AC Power Cord Connectors in Strain-Relief Devices Connecting Cables Connecting Alarm Indicators Removing the Safety Cover Alarm Indicator Terminal Block Connections Connecting a Video Terminal to the PRE Console Port Alarm Indicator Wires Exiting the Safety Cover Console Port Connection on the PRE Connecting Network Management and Signal System Cables Ethernet Network Management Cable Connections Connecting to a 100BASE-T Ethernet Network Correctly connected to the 100BASE-T Ethernet LAN Installing Network Cables to the Line Cards Auxiliary Modem Connection Powering On the System Power Fault Miswire Startup Display Configuring the Cisco 10008 Router at StartupBasic Configuration Using the Setup Facility Using the System Configuration Dialog Basic System Configuration Procedure Specify the IP address Basic Configuration in Global Configuration Mode Routerconfig # interface FastEthernet0/0/0 Formatting Flash Disks and Flash Cards Router# format disk0 CLI Name Description Managing the File SystemsFile Systems Relocating the Configuration to a Flash Disk Managing Configuration Files Larger than NvramCompressing the Configuration File Exit global configuration mode Symptom Steps to Take Troubleshooting Installation ProblemsGeneral Troubleshooting Tips Troubleshooting Ethernet Connections Switch configure terminal Troubleshooting the Console Port Serial Connection Page USA