Cisco Systems 2 manual Answer B

640 - 607

B is incorrect; the show ip route command displays the contents of the ip routing table. D is incorrect; the show interface command displays the serial interface configuration. F is incorrect; this is not a valid command.

Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 324-325, 280, and 106

Q. 45

Which of the following commands applies to an access control list to a router interface?

A.permit access-list 101 out

B.ip access-groups 101 out

C.apply access-list 101 out

D.access-class 101 out

E.ip access-list e0 out

Answer: B

Explanation: In order for an access list to be activated the ip-access group command must be used. This command activates the ip access list on an interface. Before you use the ip-access group command you must take care to ensure that you have configured an access list. If you do not the result will be permit any.

Incorrect Answers:

A, C-E are not valid commands.

Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) page 305.

Q.46

Exhibit

Router#show access-list

Extended IP access list 105

deny	tcp	any	172.30.24.64 0.0.0.63 eq smtp
deny	tcp	any	any eq telnet

Router#show ip interface e0

Ethernet0 is up, line protocol is up

Internet address is 172.17.9.60/24

Broad address is 255.255.255.255

Address determined by setup command

MTU is 1500 bytes

Helper address is not set

Directed broadcast forwarding is enabled

Outgoing access list is 105

Inbound access list is not set

Proxy ARP is enabled

Leading the way in IT testing and certification tools, www.testking.com

- 35 -