640 - 607

B.Network IP-Address

C.IP address IP-address subnet mask.

D.The exit command from the enable configuration

E.Copy running-configuration to startup-configuration

Answer: C

Explanation: The ip address command is used to start IP processing on a router (in fact the same command is also used to do the same on a switch.

Incorrect Answers:

A is incorrect; this is not a valid command.

B is incorrect; the network command is most often used to identify directly connected networks. D is incorrect; this is not a valid command.

E is incorrect; this command will copy the running config to the NVRAM.

Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 245, 133, 277.

Q. 162

When you issue the command show version, your router returns:

“Configuration register is 0x0101”

From where does the router boot?

A.ROM

B.NVRAM

C.FLASH

D.A TFTP server

Answer: A

Explanation: If you want your router to boot automatically from ROM you need to set the boot field to 1 (0x1).

Incorrect Answers:

B is incorrect; to boot from the NVRAM the boot field must be set from the range of 2 to F (0x2 to 0xF). C is incorrect; to boot from FLASH the boot system flash command would need to be used.

D is incorrect; to boot from a TFTP server the boot system tftp command would need to be used.

Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 127-130.

Q. 163

Leading the way in IT testing and certification tools, www.testking.com

- 100 -

Page 100
Image 100
Cisco Systems 2 manual When you issue the command show version, your router returns, From where does the router boot?