Cisco Systems 2 manual Answer a Explanation

640 - 607

B.(config-if)# dialer-list 1

C.(config-if)# dialer map 1

D.(config-if)# dialer-route 1

Answer: A

Explanation:

Once the above commands have been entered to enabled DDR, then the last step required is to bind the traffic destination to an interface by linking the interesting traffic definition already created. This is done with the dialer-group command. In this case the proper command would be (config-if)# dialer-group 1.

Incorrect Answers:

B is incorrect; the interesting traffic was already identified the first time the dialer-list 1 command was used.

C is incorrect; the dialer map command is used to identify the router to be dialed. In this case this has already been done.

D is incorrect; there is no such thing as a dialer route command.

Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 398-405.

Q.6

Exhibit:

RouterA# show interface s0

Serial 0 is up, line protocol is down

Hardware is HD64570

Internet address 10.1.1.1

Encapsulation HDLC, loopback not set, keepalive set (10sec)

Router A is connected to Router B, a non-Cisco router, through the network cloud. Using the command output shown what must be configured on Router A's interface s0 to change the line protocol from down to up?

A.no shutdown

B.encapsulation ppp

C.interface serial point-to-point

D.clock rate 56000

Leading the way in IT testing and certification tools, www.testking.com

- 6 -