640 - 607
Leading the way in IT testing and certification tools, www.testking.com
- 59 -
Answer: B
Explanation:
The show ipx interface command shows the status of the IPS interface and IPS parameters configured on each
interface. This includes the IPX address.
Incorrect Answers:
A is incorrect; there is no such command as show ipx addresses.
C is incorrect; the ipx network command is used to enable IPX routing on a particular interface. The <number>
parameter is used to identify the network that IPX is enabled on.
D is incorrect; whenever you want to display something on a Cisco interface you use a show command. There
is no such command as display ipx addresses.
E is incorrect; there is no such command as show ipx routing details. To show the contents of a routing table
you would use the show ipx route command.
Steve McQuerry. Interconnecting Cisco Network Devices. (Cisco Press: 2000) pages 345-347.
Q. 89
Which commands should you use to enable IGRP routing?
A. router igrp 100
network 192.168.1.0
network 10.0.0.0
B. router igrp 100
network 192.168.1.0
network 10.2.0.0
C. router igrp 100
network 192.168.1.0 192.168.1.1
network 10.2.0.0 10.2.1.1
D. router igrp 100
network 192.168.1.0 255.255.255.0
network 10.2.0.0 255.255.0.0
Answer: A
Explanation: To enable IGRP you use the router igrp and network commands. Please note an autonomous
system number must follow the router igrp command and a valid network number must follow the network
command. For RIP and IGRP network numbers must be a major class network number and does not include
neither subnet numbers nor individual addresses.