36
Avaya Definity Gx/PBXLink Integration Guide for CiscoUnity 4.0
OL-3105-15
Avaya Definity Gx/PBXLink Integration Guide for CiscoUnity 4.0
Testing the Integration
To Set Up Supervised Transfer on CiscoUnity
Step1 In the Cisco Unity Administrator, go to the Subscribers > Subscribers > Call Transfer page.
If the name of the test subscriber is not displayed, click the Find icon (the magnifying glass) in the title
bar, then click Find, and select the name of the test subscriber in the list that appears.
For more information on transfer settings, refer to the “Subscriber Template Call Transfer Settings”
section in the Cisco Unity Administrator Help.
Step2 Under Transfer Type, click Supervise Transfer.
Step3 Set the Rings to Wait For field to 3.
Step4 Click the Save icon.
To Test Supervised Transfer
Step1 From Phone 2 , enter the access code necessary to get an outside line, then enter the number outside
callers use to dial directly to CiscoUnity.
Step2 On the Status Monitor, note which port handles this call.
Step3 When you hear the opening greeting, enter the extension for Phone1. Hearing the opening greeting
means that the port is configured correctly.
Step4 Confirm that Phone1 rings and that you do not hear a ringback tone on Phone 2. Instead, you should
hear the indication your phone system uses to mean that the call is on hold (for example, music or beeps).
Step5 Leaving Phone1 unanswered, confirm that the state of the port handling the call remains “Busy.” This
state and hearing an indication that you are on hold mean that CiscoUnity is supervising the transfer.
Step6 Confirm that, after three rings, you hear the greeting for the test subscriber. Hearing the greeting means
that Cisco Unity successfully recalled the supervised-transfer call.
Step7 During the greeting, hang up Phone 2.
Step8 On the Status Monitor, confirm that the state of the port handling the call changes to “Idle.” This state
means that the port was successfully released when the call ended.
To Delete the Test Subscriber
Step1 In the Cisco Unity Administrator, go to the Subscribers > Subscribers > Profile page.
If the name of the test subscriber is not displayed, click the Find icon (the magnifying glass) in the title
bar, then click Find, and select the name of the test subscriber in the list that appears.
Step2 In the title bar, click the Delete Subscriber icon (the X).
Step3 Click Delete.