Cisco Systems 6500 Ssl-proxy context name No ssl-proxy context name, Description description

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

ssl-proxy context

ssl-proxy context

To enter the SSL context submode and define the virtual SSL context, use the ssl-proxy context command. Use the no form of this command to remove any commands that you have entered in the SSL context subcommand mode from the configuration.

ssl-proxy context [name]

no ssl-proxy context name

Syntax Description	name	Name of the context.
Defaults	The default context name is “Default.”

Command Modes

Command History

Global configuration

Release	Modification
SSL Services Module	Support for this command was introduced on the Catalyst 6500 series
Release 3.1(1)	switches.

Usage Guidelines The name argument is case sensitive.

After you enter the ssl-proxy context command, the prompt changes to the following:

ssl-proxy(config-context)#

After you enter the context submode, you can use the context submode commands listed in Table 2-10to configure the context services.

Table 2-10 Context Submode Commands

Command	Purpose and Guidelines	Defaults
default	Set a command to its defaults
description description	(Optional) Allows you to enter a short description
	for this context.
exit	Exit from context configuration mode.
maxconns connections	(Optional) Configures the maximum number of	65536
	connections for this context. Valid values are from
	1 to 65536.
natpool name start_ip_addr	Configures the NAT pool settings. See the “natpool”
end_ip_addr netmask netmask	section on page 2-30.
policy health-probe tcp	Configures the TCP health probe policy. See the
policy-name	“policy health-probe tcp” section on page 2-31.
	Catalyst 6500 Series Switch SSL Services Module Command Reference
OL-9105-01			2-87