Cisco Systems 6500 manual Ssl-proxy config# interface ssl-proxy

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

interface ssl-proxy

•type time—Specifies the preemption type and delay; valid values are as follows:

–minimum time—Specifies the minimum delay period in delay seconds; valid values are from 0 to 3600 seconds (1 hour).

–reload time—Specifies the preemption delay after a reload only.

–sync time—Specifies the maximum synchronization period in delay seconds.

•timers [msec] hellotime holdtime—Configures the time between hello packets and the time before other routers declare the active hot standby or standby router to be down; valid values are as follows:

–msec—(Optional) Interval in milliseconds. Millisecond timers allow for faster failover.

–hellotime—Hello interval (in seconds); valid values are from 1 to 254 seconds. If you specify the msec keyword, the hello interval is in milliseconds; valid values are from 15 to

999 milliseconds. The default is 3 seconds.

–holdtime—Time (in seconds) before the active or standby router is declared to be down; valid values are from x to 255; x is the hellotime plus 50 milliseconds and is rounded up to the nearest 1 second. If you specify the msec keyword, the holdtime is in milliseconds; valid values are from y to 3000 milliseconds; y is greater than or equal to 3 times the hellotime and is not less than 50 milliseconds. The default is 10 seconds.

Examples This example shows how to enter the subinterface configuration submode:

ssl-proxy (config)# interface ssl-proxy 0.6

ssl-proxy (config-subif)#

This example shows how to configure the specified subinterface with an IP address and subnet mask:

ssl-proxy(config-subif)#ip address 208.59.100.18 255.0.0.0

ssl-proxy (config-subif)#

This example shows how to configure the HSRP on the SSL module:

ssl-proxy(config)#interface ssl-proxy 0.100 ssl-proxy(config-subif)#ip address 10.1.0.20 255.255.255.0 ssl-proxy(config-subif)#standby 1 ip 10.1.0.21 ssl-proxy(config-subif)#standby 1 priority 110 ssl-proxy(config-subif)#standby 1 preempt ssl-proxy(config-subif)#standby 2 ip 10.1.0.22 ssl-proxy(config-subif)#standby 2 priority 100 ssl-proxy(config-subif)#standby 2 preempt ssl-proxy(config-subif)#end

ssl-proxy#

Related Commands show interfaces ssl-proxy show ssl-proxy vlan

Catalyst 6500 Series Switch SSL Services Module Command Reference

OL-9105-01 2-29