Cisco Systems 6500 manual Policy health-probe tcp, Syntax Description Defaults Command Modes

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

policy health-probe tcp

policy health-probe tcp

Syntax Description

Defaults

Command Modes

To enter the TCP health probe configuration submode, use the policy health-probecommand. In TCP health probe configuration submode, you can define the TCP health probe policy that is applied.

policy health-probe tcp policy-name

policy-name TCP health probe policy name.

The defaults are as follows:

•failed-interval is 60 seconds.

•interval is 30 seconds.

•maximum-retry is 0.

•open-timeoutis 80 seconds.

•port is the port of the server IP address that you configured in the SSL server proxy service.

Context subcommand mode

Command History	Release	Modification
	SSL Services Module	Support for this command was introduced on the Catalyst 6500 series
	Release 3.1(1)	SSL Services Module.

Usage Guidelines Table 2-9lists the commands that are available in TCP health probe policy configuration submode.

Table 2-2 TCP Health Probe Submode Command Descriptions

Syntax	Description
interval seconds	(Optional) Allows you to set the interval between probes in seconds (from
	the end of the previous probe to the beginning of the next probe) when the
	server is healthy. The default is 30 seconds. The valid range is from 30 to
	300 seconds.
failed-interval seconds	(Optional) Allows you to set the time between health checks after the
	service has been marked as failed. The default is 60 seconds. The valid
	range is from 30 to 3600 seconds.
maximum-retry retries	(Optional) Sets the number of failed probes that are allowed before
	marking the service as failed. The default is 0 retries. The valid range is
	from 1 to 5 retries.

Catalyst 6500 Series Switch SSL Services Module Command Reference

OL-9105-01 2-31