Cisco Systems 6500 manual Standby version 1, Specifies Hsrp version, 116

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

standby version

standby version

To change the version of the Hot Standby Router Protocol (HSRP), use the standby version command:

			standby version {1 2}
Syntax Description		1	Specifies HSRP version 1.
	2		Specifies HSRP version 2.

Defaults

Command Modes

Command History

The default HSRP version is 1.

Subinterface configuration submode

Release	Modification
SSL Services Module	Support for this command was introduced on the Catalyst 6500 series
Release 2.1(1)	switches.
SSL Services Module	The command mode for this command was changed from Proxy-VLAN to
Release 3.1(1)	Subinterface.

Usage Guidelines HSRP version 2 addresses limitations of HSRP version 1 by providing an expanded group number range of 0 to 4095.

HSRP version 2 will not interoperate with HSRP version 1. An interface cannot operate both version 1 and version 2 because both versions are mutually exclusive. You cannot change from version 2 to version 1 if you have configured groups above 255. Using the no standby version command sets the HSRP version to the default version, version 1.

If an HSRP version is changed, each group will reinitialize because it now has a new virtual MAC address.

Examples This example shows how to configure HSRP version 2:

ssl-proxy (config-subif)# standby version 2 ssl-proxy (config-subif)#

	Catalyst 6500 Series Switch SSL Services Module Command Reference
2-116	OL-9105-01