3-9
Cisco CGS 2520 Hardware Installation Guide
78-19377-02
Chapter 3 Power Supply Installation
Power Supply Module Installation
Note The power supply module 1 connection is labeled PSU1, and the power supply module 2 connection is
labeled PSU2. Make sure that you connect the wires to the correct terminal screws.
Step 3 Use twisted-pair copper wire (14- to 18-AWG) to connect from the power-input terminal to the power
source.
Note Use 12-AWG (minimum) for the low-voltage DC power supply module. Use 16-AWG
(minimum) for the high-voltage AC or DC power supply module.
Step 4 Strip each of the two wires to 0.25 inch (6.3 mm) ± 0.02 inch (0.5 mm). Do not strip more than 0.27 inch
(6.8 mm) of insulation from the wire. Stripping more than the recommended amount of wire can leave
exposed wire from the connector after installation.
Figure 3-11 Stripping the Input Power Source Wire
Step 5 Insert the wire into a spade terminal, and crimp the it to the wire. You can also use a ring or flanged spade
terminal as listed in the Equipment That You Need, page 3-3.
100-240V~, 50-60Hz, 2A
5
100-240V~, 50-60Hz, 2A
2A2A
10A
10A
5
2
1
4
3
76
98
11
10
14
13
512
207241
0.25 in. (6.3 mm) ± 0.02 in. (0.5 mm)
60531