Cisco Systems CP6921CK9 manual Before You Begin, Installing the Bracket

Appendix E Installing the Wall Mount Kit for the Cisco Unified IP Phone 6921, 6941, and 6961

Before You Begin

Before You Begin

You will need these tools to install the bracket:

•#1 and #2 Phillips-head screwdrivers

•Level

You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular telephone jack. For more information on phone installation requirements and warnings, see the Setting Up the Cisco Unified IP Phone chapter.

Installing the Bracket

To install the phone on the wall, perform the following steps:

Procedure

Step 1 Mount the wall bracket in the desired location (Figure E-2). You can install the bracket over an Ethernet jack, or you can run the Ethernet network cable to a jack nearby.

a.Use the level to ensure the bracket is level, then use a pencil to mark the screw holes.

b.Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor into the wall.

c.Screw the anchor clockwise into the wall until it is seated flush.

d.Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.

Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP)

E-2 OL-19025-01