
Chapter 2 Switch Installation
Installing and Removing SFP Modules
For detailed instructions on installing, removing, and cabling the SFP module, refer to your SFP module documentation.
Installing SFP Modules into SFP Module Ports
This section provides instructions for installing an SFP module that has a
Caution We strongly recommend that you do not install or remove
Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP modules more often than is absolutely necessary.
Note Refer to the Installation Notes for the Cisco Small
Figure 2-4 shows an SFP module that has a bale-clasp latch.
Figure 2-4 SFP Module with a Bale-Clasp Latch
86575
To insert an SFP module into the SFP module port, follow these steps:
Step 1 Attach an
Note On some SFP modules, the send and receive (TX and RX) markings might be replaced by arrows that show the direction of the connection, either send or receive (TX or RX).
Step 3 Align the SFP module in front of the port opening.
Step 4 Insert the SFP module into the port until you feel the connector on the module snap into place in the rear of the port.
Cisco ME
|
| |
|