Cisco Systems ME 4924-10GE manual

Appendix C Initial Configuration for the Switch

Entering the Initial Configuration Information

FastEthernet1				unassigned	YES	unset		up	up
!--- Output			suppressed.
Switch1#	show ip			route
Codes: C	- connected, S - static, I - IGRP,						R - RIP, M - mobile,		B - BGP
D	- EIGRP, EX - EIGRP external,					O - OSPF, IA - OSPF inter			area
N1		-	OSPF	NSSA external type 1,		N2 -	OSPF NSSA external type 2
E1		-	OSPF	external type 1, E2 -		OSPF	external type 2, E -		EGP

i- IS-IS, L1 - ISIS level-1, L2 - ISIS level-2, ia - ISIS inter area * - candidate default, U - per-user static route, o - ODR

P - periodic downloaded static route

Gateway of last resort is 172.16.1.1 to network 0.0.0.0

	172.16.0.0/24	is subnetted, 1 subnets
C	172.16.1.0	is directly connected, Vlan1
S*	0.0.0.0/0 [1/0] via 172.16.1.1

Switch1#

Step 15 Save the running configuration:

Switch1# copy system:running-config nvram:startup-config

You have now completed the initial configuration of the switch.

To use the CLI to perform additional configuration or management tasks, enter commands at the Switch> prompt through the console port by using a terminal program or through the network by using Telnet. For configuration information, refer to the switch software configuration guide or the switch command reference.

Cisco ME 4924-10GE Ethernet Switch Hardware Installation Guide

C-6 OL-10071-01