Cisco Systems OL-5532-02 manual Defining Split Tunneling Networks Optional

Chapter 4 Remote Access VPN Services

Creating Remote Access VPN Policies

Step 6 Click Next to continue to the Split Tunneling Network page as shown in Figure 4-11in the “Defining Split Tunneling Networks (Optional)” section on page 4-12.

Defining Split Tunneling Networks (Optional)

You can enable or disable split tunneling for remote users. To set the split tunneling parameters, perform the following steps:

Step 1 The Remote Access VPN Policy – Split Tunneling Network List page appears as shown in Figure 4-11.

Note From the ISC home page, you can navigate to the Split Tunneling Network page by clicking Service Design > Policies > Create > IPsec Policy > Remote Access VPN Policy, entering values for the General Editor and Address Pools pages, and then clicking Split Tunneling.

Figure 4-11 Remote Access VPN Policy – Split Tunneling Network List Page

Step 2 Follow the instructions in Table 4-4to choose your split tunneling options. For example, click Create to add IP addresses to the split tunneling network list.

Note Once the list is populated using Create, Generate, or both options, you can edit the list until it contains the desired networks from which traffic must travel through the IPsec tunnel.

Cisco IP Solution Center Integrated VPN Management Suite Security User Guide, 3.2

4-12 OL-5532-02