Chapter 3 Configuring Ports and Interfaces

Enabling Link Aggregation

LAG is typically configured using the Startup Wizard, but you can enable or disable it at any time through either the GUI or CLI.

Using the GUI to Enable Link Aggregation

Follow these steps to enable LAG on your controller using the GUI.

Step 1 Click Controller > General to access the General page (see Figure 3-13).

Figure 3-13 General Page

Step 2 Set the LAG Mode on Next Reboot parameter to Enabled.

Note Choose Disabled if you want to disable LAG.

Step 3 Click Save Configuration to save your changes.

Step 4 Reboot the controller.

Cisco Wireless LAN Controller Configuration Guide

 

OL-8335-02

3-29

 

 

 

Page 85
Image 85
Cisco Systems OL-8335-02 manual Using the GUI to Enable Link Aggregation, General