Router# config terminal

Reference Information

Step 3 To enable the router, copy the image new.image to the Flash memory card, make this image in the Flash memory card (in slot 0) the default boot image, and reboot the router, use the following series of commands:

Router> en

Password:

Router# copy tftp:new.image slot0:new.image

20575008 bytes available on device slot0, proceed? [confirm] Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet1/0): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[OK - 7799951/15599616 bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC Router#

Note In the previous example, the exclamation points (!!!) appear as the ﬁle is downloaded and the “C” characters signify calculation of the checksum, which is a veriﬁcation that the ﬁle has been correctly downloaded to the Flash memory card.

Router(config)# no boot system

Router(config)# boot system flash slot0:new.image

Router(config)# ^z

Router# copy running-config startup-config

Router# reload

When the system reloads it will boot the image new.image from the Flash memory card in slot 0.

447000 Series Route Switch Processor (RSP7000) Installation and Conﬁguration in the Cisco 7000 Series Routers

Cisco Systems RSP7000 manual Router# config terminal

Models: RSP7000

Router# copy tftp:new.image slot0:new.image

Router# config terminal