Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-04 v
This preface describes who should read the SCE 2000 4xGBE Installation and Configuration
Guide, how it is organized, and its document conventions.
Document Revision History
Cisco Service Control Release Part Number Publication Date
Release 3.0 OL-7824-03 December, 2005
DESCRIPTION OF CHANGES
Added the following new features:
• Redundant Management (Mng) port.
Release 2.5.7 OL-7824-02 August, 2005
Audience
This guide is for the networking or computer technician responsible for installing and configuring
the SCE 2000 platform on-site. To use this publication, you should be familiar with
telecommunications equipment and installation procedures, as well as electronic circuitry and
wiring practices. You should also have experience as an electronic or electromechanical
technician.
This installation guide explains the initial hardware installation and basic configuration
procedures for the SCE 2000. It contains procedures for unpacking and installing the device and
performing basic configuration via the setup wizard. After completing the installation and basic
configuration procedures covered in this guide, you will then use the appropriate companion
publications to more completely configure your system.
This guide contains instructions on how to install and run the SCE 2000 platform. This guide
assumes a basic familiarity with telecommunications equipment and installation procedures.