Citizen Systems iDP3550, iDP3551 user manual Operation Panel and Display of Error

iDP3550/3551 User ’s Manual

4.12Operation Panel and Display of Error

1.POWER lamp (Green)

This lamp is illuminated when the power is supplied.

2.ERROR lamp (Green)

This lamp is illuminated or blinks to indicate each error.

Error Indication			SEL/ERROR Lamp	Buzzer	Resetting Method
Mechanical Error			Quick blinking	Sounds continuously for	Reset the Power
				approx. 1 second	switch.
Paper End			Blinks.	Repeats a short 4-time	Set a new paper roll.
			(Once a second)	sound twice at
				intervals of 0.5 second.
Paper Near End			Blinks.	Repeats a short 4-time	Set a new paper roll.
			(Once a second)	sound twice at
				intervals of 0.5 second.
Cutter Motor Lock			Quick blinking	Sounds continuously	Eliminate a paper
(iDP3551 only)			(Twice a second)	for approx. 1 second.	jam.
Mechanical Error	: If the printer mechanism has a greater load due to a paper jam, etc., the buzzer
		will sound and the SEL/ERROR lamp will blink to stop the printer mechanism.

Paper End (iDP3550F ,

iDP3551)

Paper Near End

(iDP3550F , iDP3551)

:If the printer has run out of paper, the paper sensor in the paper path near the print head will detect the end of the paper roll, turn on the buzzer, and blink the

SEL/ERROR lamp to stop the printer mechanism. If the paper is inserted into the paper path, the paper will be loaded. (See 4.6 Inserting the Paper)

:If the paper is running out, the paper near end sensor will be activated to turn on the buzzer and make the SEL/ERROR lamp blink. Even after the paper near end is detected, a command can be used to print by the specified number of lines. (See a description on the command for setting the number of print lines after paper near end detection)

Cutter Motor Lock	: If the cutter position detection sensor in the cutter unit is left turned on or off
(iDP3551 only)	for approx. 1 second while the cutter motor is running, cutter operation and
	printing will be suspended, determining it to be motor lock.
Backup Data Clear	: When the power is turned on, depending on the SEL switch operation, the
	backup data in the input buffer will be cleared according to the flowchart on
	the next page.
	To clear the input buffer, turn on the power while pressing the SEL switch.
	The following messages will be printed.
	“Clear Data in Buffer”
	“Cleared Data in Buffer”
	To print the data in the input buffer, simply turn the power on.	The following
	message is printed and the data in the input buffer is printed.
	“Power Down(Data in Buffer)”
Test Print	When the power is turned on while the LF switch is pressed, a test print is
	carried out.
	19	CITIZEN