Classe Audio SSP-800/CT-SSP owner manual Only one speaker seems to be playing

3 Only one speaker seems to be playing.

PIf the problem occurs with all inputs, check the interconnecting cables between the preamp and the power amp. Also check the speaker wires for secure connections.

PIf the problem occurs with only one input, check the input balance control setting of that input: select the problem input, then access the input balance control by touching Controls from the Home page of the front panel touchscreen, then select System Trims -> Level Trims, and then verify the balance control for the speakers. Check the speakers are active on the configuration assigned to this input.

PCheck that the speakers are active on the configuration assigned to this input.

PCheck the interconnect cables between the source component and the SSP.

4 The IR remote control does not seem to function.

P Ensure that there are no obstacles between the IR remote and the IR sensor, located to the right of the Mute button.

P Replace the batteries in the remote control.

5 There is a hum coming out of the speakers.

PIf you are using single-ended interconnects, make sure they are not placed alongside any AC power cords. Also make sure that they are not too long – long single-ended interconnecting cables have a natural tendency to pick up noise even when shielded.

PIf any source components are connected to cable TV, try disconnecting the cable television line from the source component. If the hum goes away, you need an isolation device between your cable TV converter and the source component.

Your Classé dealer can help you obtain one of these inexpensive devices.

6 There is a hum coming from the SSP.

PThis symptom suggests that there are a lot of DC offset or other artifacts on your AC mains line. Try connecting to another AC circuit – not merely a different plug, but a completely different outlet.

PCheck to see if you have any halogen lighting or dimmers on the same AC circuit as the SSP as they can cause the power supply transformers to hum.

7If there is no video or bad video displayed on a display device.

P Check the Menu -> Status information on the front panel touchscreen to verify the status of the incoming video. If no video signal is present, recheck the listed video input connection and the video source. Note that for 3D sources a 3D-capable display device is required.

P If a valid video signal is present, press the Preview button on the Home page. The preview should show the incoming video signal. If the touchscreen is blank, verify the incoming source is in fact transmitting the desired video program.

P If the preview image has improper colors from a component source, either the component source is transmitting an RGB signal (unsupported) or the Pr and Pb wires are crossed.

63