Programming Procedures HotCup Operators’ Guide
6740001 38 November, 2007
Programming ProceduresSOME CONVENTIONS
The pages that follow contain all the programming procedures for the HotCup. If you need to do a
specific task, you can find it immediately by using the Programming Index. Most of the procedures
have things in common, and here is a short guide to help you through these conventional
presentations:
• All programming procedures assume that you are starting with the standby message showing
in the display. If not, just press until you get there.
• Each programming procedure is highlighted by a pointing hand: so it will stand out.
• To exit a mode (CONTINUE) at any time, press . Sometimes you may have to press
the key more than once in order to exit all the way to the standby message.
• Text that looks like this:DISPLAY represents what you will see in the display on the
monetary panel.
• Definitions and helpful information will appear in shadow boxes:
THE SUPERVISOR MODE
The supervisor is allowed to do things that a normal user cannot, like controlling access to certain
modes. The supervisor can lock out any of the programming modes to anyone who does not have
the right "key". Once a supervisor enters the proper code, he or she will be able to:
• Change the supervisor access code
• Lock out any or all of the service keypad modes
• Select whether price lines are used
• Set whether data is cleared after being downloaded into a portable data collection device
• Grant or deny access to data items during DATA RECALL
• Mo dify the machine configuration
GAIN ACCESS TO THE SUPERVISOR MODE
a. Press . The display shows: ENTER CODE. You must enter the four-digit supervisor
code within 6 seconds to gain access.
NOTE
A new machine has a factory-set supervisor code of 0000.
b. When you have entered the right code, you will hear two beeps and see UNLOCKED in the
display.