CMS Products 674, 676 LTDIS off, ltdis on

HotCup Operators’ Guide Hot Drink Setup
November, 2007 51 6740001
VIEW OR SET THE HOT WATER TANK TEMPERATURE
a. Press then until the display shows SET 202 °F . In this example, 202° is the
water tank temperature setpoint in degrees Fahrenheit. If a decimal point appears next to the
“F”, the heater is on.
b. If desired, enter a new setpoint in the accepted range of 149° - 205° F (65° - 96° C).
NOTE
The lower limit for vending is 20° below setpoint, up to a
maximum of 180° F (82° C).
c. To change display units (replace the “F” with a “C” for Celsius), press .
d. Continue.
SET UP LOW TEMPERATURE DISPENSING
a. Press then press until the screen displays either:
LTDIS off. This causes the machine to operate the same as the previous HotCup Center.
For example, with a setpoint temperature of 202º F the machine will inhibit vending when the
water tank temperature reaches 182º F.
-or-
ltdis on. Allows vending to a water tank temperature of 140º F.
b. Press to change between ON and OFF.
c. Continue.