Appendix B. Power Cord Set Requirements
B.1
The wide range input feature of your computer permits it to operate from any line voltage from 90 to 264 volts AC.
The power cord set received with the computer meets the requirements for use in the country where you purchased the equipment.
Power cord sets for use in other countries must meet the requirements of the country where you use the computer. For more information on power cord set requirements, contact your Compaq authorized reseller or service provider.
General Requirements
The requirements listed below are applicable to all countries:
1.The length of the power cord set must be at least 6.00 feet (1.8 m) and a maximum of 9.75 feet (3.0 m).
2.All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the country where the power cord set will be used.
3.The power cord set must have a minimum current capacity of 10A and a nominal voltage rating of 125 or 250 volts AC, as required by each country's power system.
4.The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13 connector, for mating with appliance inlet on the Switch Box.
===========================================================================
CountryAccredited AgencyApplicable Note Numbers
===========================================================================
Australia | EANSW | 1 |
Austria | OVE | 1 |
Belgium | CEBC | 1 |
Canada | CSA | 2 |
Denmark | DEMKO | 1 |
Finland | SETI | 1 |
France | UTE | 1 |