Telephone | cord | is | not | Check and | secure |
plugged in all | the way. | telephone | connection. | ||
Necessary | drivers | are | Install drivers. | ||
not installed (turned |
|
| |||
on).
PC Card modem or fax | You are trying to access | See Chapter 8 | to verify | |
card does not work. | the card | using the wrong | COM port. |
|
| COM port. |
|
|
|
| The card | conflicts with | See Chapter 8 | to verify |
| a serial | device. | address. |
|
| The card | is not | Use supported | cards |
| supported. | only. |
| |
Modem network | PC | Network driver is not | Install driver. |
Card does not | work. | installed or is not set |
|
|
| up properly. |
|
|
| Telephone cord is not | Verify telephone |
|
| properly connected. | connection. |
Memory or | storage | SRAM | and flash | memory | Install driver. | |
card does | not work. | cards require the | memory |
| ||
|
| card | driver to | be | loaded |
|
|
| (turned on). |
|
|
| |
Flash memory cards require the Microsoft FlashFile System to be loaded.
Hard drives on flash mass storage cards require the PC Card ATA driver to be loaded.
You are trying to access the hard drive card using the wrong drive letter.
The card is not | Contact your | Compaq |
supported. | authorized service | |
| provider for | a list of PC |
| Card cards tested | |
| successfully | in Compaq PC |
| Card platforms. | |
===========================================================================
Solving Pointing Device Problems
Some common causes and solutions for EasyPoint II pointing device problems are listed in the following table.