Manuals / Compaq / Computer Equipment / Scanner

Compaq P/N DOC-FB4B manual The Info Technician, Installing the device driver, Figure.2.1

Models: P/N DOC-FB4B

1 29

Download 29 pages 1.31 Kb

Page 10

The Info Technician

The Info Technician

TheInfoTechnicianisanautomaticinstallationutilitythateditsand installs the scanner’s device and TWAIN drivers. These drivers provide the link between the scanning hardware, the scanning application, and the computer’s operating system.

Installing the device driver

Run the Info Technician to install the scanner drivers. To do so:

1.Place the Info Scanner System Software CD-ROM in the CD Rom drive. Select Run from the File Menu in the Windows Program Manager (Windows 3.1x), or select Run after clicking Start on the taskbar (Windows 95).

2.Typed:\install\setup at the command line (substitute the appropriate drive letter if the CD-ROM drive is not the “d” drive).Click OK.

3.Select the Scanner Driver: Click on the picture displaying the Image Reader Express scanner.

4.ClickOKtoinstalltheTWAINdriverinthe“c”driveor substitutetheappropriatedriveletterforthedrivethat contains the Windows directory. The screen will inform you that the Installation was Successful. ClickContinue to begintheInfoCentersoftwareinstallation(Figure2.1).

Figure.2.1

2-2

Image 10

Compaq P/N DOC-FB4B manual The Info Technician, Installing the device driver, Figure.2.1

Contents

User’s Guide Compact Color Flatbed ScannerImageReader Express P/N DOC-FB4BThe Info Technician Copyright 1994 - 1997 All Rights Reserved InfoPhone 408 538-2500 Fax 408 580DivisionStreet Campbell CAInstallingtheapplicationsoftware Table of ContentsScanner Installation and Info Technician Scanning features and controlsPage Chapter Using this manualWhat is TWAIN? IntroductionA note about application software System requirements Package contentsImageReader Express scanner Interfacecable Power adapter Quick Start Guide This User’s GuideDOS 5.0 or later with Windows 3.1x, or higher CD-ROM drive Minimum and recommended system requirements are486 processor or 100% compatible 8 MB RAM minimum 16 MB RAM recommendedConnecting the scanner Scanner Installation and Info TechnicianInstallation Using the pass-throughRun the Info Technician to install the scanner drivers. To do so Installing the device driverThe Info Technician Figure.2.1Figure2.2 Installing the application softwarePerform Utility Diagnostic figure2.3To Change Your Parallel Port Mode Setting in most systems 4. Go back to the main menu 5. Exit and save changesPage Hardware features Using your scannerScanning features and controls PowerPaper loading Remove paper clips, pins or staples LetwetpaperdryfirstSoftware controls Paper sizeSettings Preview WindowG a m m a Image InformationScan Scan ModePre-scan PanelResolution scanatScale RefertothechartbelowforresolutionsettingguidelinesIC = InfoCenter, IPG = Image Pals GO Inverse1. Start the image editing application software in Windows Scanning imagesSelect the TWAIN source 2. Choose Select Source from the File menuThe scanning process Other scanning features6. Click Cancel to close the Flatbed Scanner window To scan an image3-10 General Scanning Tips TroubleshootingAppendix A 16-bit versus 32-bit applicationsBi-Directional Printers Printer Problems? Cannot print to printerTWAIN Errors About the pass-through porta Check your cable connection and retry scanning Error messages“Error 82 Scanner not Found” message when attempting a scan “Image Transfer Failed”Changing Your Parallel Port Mode Scanner care 2. Ifnecessary,cleanthescannerglasswithasoftlenscloth8. The scanner operates best in temperatures of 10C to 40C 50F to104F FCC radio frequency interference statementReorient or relocate the receiving antenna Limited two year warrantyInfo Service Center 580DivisionStreet Campbell, CA Increase the separation between the equipment and receiver