FINISHING CURVED EDGES ON THE
ABRASIVE BELT
CURVED EDGES
Finish outside curves on the abrasive belt and inside
curves on the idler pulley.
FINISHING SMALL END SURFACES AND CURVED EDGES ON THE ABRASIVE DISC
Move the work across the "Down Side" of the face of the abrasive disc. For accuracy, use a miter gauge_
NOTE: Use a combination square to square the miter gauge to the face of the disc. If it is not squat e pull out the index pin, loosen the miter gauge knob and move the
miter gauge slightly until it is square. Without moving the miter gauge, tighten the knob securely.
Applying the workpiece to the "Up Side" could cause it to fly up (kickback) which could be hazardous.
The table may be tilted for beveled work.
J
SQUARE
"_ | MITER GAUGE | |
\ | ||
|
/
