trouble shooting

WARNING: FOR YOUR OWN SAFETY, TURN

SWITCH "OFF" AND REMOVE PLUG FROM

POWER SOURCE OUTLET BEFORE TROUBLE

SHOOTING YOUR SANDER,

TROUBLE SHOOTING CHART

TROUBLE

 

 

 

 

PROBABLE

CAUSE

 

Motor wd! not

run.

1,

Defective On-Off switch.

 

 

 

 

 

Defective

switch

cord.

 

 

 

 

 

Defective

switch

box

receptacle,

 

 

 

2,

Motor

protector

open, (only

if

 

 

 

 

your motor is equipped with an

 

 

 

 

overload

protector),

 

 

 

 

 

3.

Burr_ed out motor.

 

 

Machine

slows

down

1.

V-Belt

too

loose.

 

 

 

when finishing,

 

 

 

 

 

 

 

 

 

 

 

 

 

2.

Applying

too much pressure

to

 

 

 

 

workpiece.

 

 

 

 

 

 

 

3.

Too much tension on abrasive

 

 

 

 

belt.

 

 

 

 

 

 

 

Abrasive

Belt

Slips

1,

Not

enough

tension.

 

 

Abrasive

Belt

runs

1.

Not

tracking

properly.

 

 

off pulleys.

 

 

 

 

 

 

 

 

 

 

 

 

 

2.

Not

enough

tension.

 

 

Wood burnswhile

1.

Abrasive

disc or belt

is glazed

with

finishing.

 

 

 

sap.

 

 

 

 

 

 

 

REMEDY

1. Replace defective pa_ts before ,4sing b!!l_ dsc sai_(ler agai_

2. Reset p_otector after motor has cooled

3.Coqsuit S_!a!s S_!TvI(;e, Ally attemt.)t ._o lepa_ this

motor may £reate a HAZARD urtfe_s r_;t_air ts clon_ by a qualified service techr_icia_. Repair service is available at your nearest Sears Store.

1.Increase belt tension, see Assembly Section, "Motor Pulley Belt Gtlard and Motor InstaUation."

2.Ease up on pressure.

3, Adjust tension, see Assembly Section, "fnstaliing and Adjusting Abrasive _3elt."

1.Adjust tension, see Assembly Section, "Installing and Adjusting Abrasive Belt."

1, Adjust tracking, see Assembly Section, "'Installing and Adjusting Abrasive Belt."

2.Adjust tension, see Assembly Section. "Installing and Adjusting Abrasive Belt."

t. Replace dis(: or belt.

23

Page 23
Image 23
Craftsman 113.225900 Motor wd! not, Box, Protector Open, only, Applying, Workpiece Too much tension on abrasive, Not