Craftsman 113.225931, 113.225909, 113.225900 manual Unpacking and checking, Contents

CONTENTS

SAFETY INSTRUCTIONS		FOR POWER TOOLS	2
ADDITIONAL SAFETY NSTRUCTIONS FOR BELT AND
DISC SANDER			3
ELECTRICAL	REQU REMENTS		5
Check Motor Rotation			5
UNPACKING	AND CHECKING CONTENTS		6
ASSEMBLY			7
Assembling Steel Legs			8
Mounting Belt and Disc Sander on Steel Leg Set ...,.. 8
Installing	Sanding	Disc and Dust Trap	9
Installing Motor, V-Belt Tensioning and Tracking .... 1!
On-Off Switch			12
Installing	Work Table		14
Installing Abrasive Belt Tensioning and Tracking .... 14
Installing	Belt Dust	Trap	15
Installing	Backstop	.....................................	16
GETTING TO KNOW YOUR SANDER			16
Belt Adjusting Screws			17

Belt Locking Screws			17
Work Table Tilt Lock Screw			17
Backstop	Lock Screw		18
Belt Table	Locking	Bolts	18
Belt Table	Stop		18
BASIC OPERATION			19
Surface Finishing		on tne Abrasive Belt	20
End Finishing on the Abrasive Belt			20
Finishing	Curved Edges on the Abrasive Belt		21
Finishing Small End Surfaces and Curved Edges
on Disc			21
MAINTENANCE	................................................................		22
Motor Maintenance		and Lubrication	22
LUBRICATION	..................................................................		22
Recommended Accessories			22
TROUBLESHOOTING			23
REPAIR PARTS	................................................................		25
Motor Connections		...................................................	29

unpacking and checking

Model 113.225900 Belt and Disc Sander is shipped complete in one carton but DOES NOT INCLUDE Steel Legs or Motor.

Model 113.225931 Belt and 0isc Sander is shipped

complete in one carton and INCLUDES Steel Legs and

Motor.

Separate all parts from packing materials and check each"

item with Ilustration and "Table of Loose Parts." Make

certain all items are accounted for, before discarding any packing material.

If any parts are m_ss_ng, do not attempt to assemble the Belt and Disc Sander. plug in the power core. or _urn the

switch on until the missing parts are obtained aria installed correcti V.

Using a 112" wrench, remove the plywood attached to the machine. Save the nuts and bolts and washers. You Wil] need them for attaching the machine to the base

contents

TOOLS NEEDED - - - ,

3/4"7/16"1/2"WrenchWrenChwrenchMedium_:2Screwdriver_ScrewdrlvelC°mbinati°nSquarePhilbps. Square!i

3/8"	Wrench		SQUARE	MUST BE TRUE.
		COMBINATION
DRAW		LIGHT	J	8OAR°	3/4 THICK
LINE	ON	BOARO		TNIS EDGE MUST B£
AEOf_G	THIS EIE)GE I_'_		_	PERFECTLY	STRAIGHT

I "N.I

[ q_u

SHOULD NOGAPOROVE,LAPNEREWHEN

SOUARES_L'PPEOOVE" _NDOTTEOPOS,T_ON

6