assembly
B. Find five 378" Pan Head
among the loose parts.
7.Place Disc Dust Trap on your workbench and screw m
five Pan Head "Thread Cutting Screws," 3/8" long. Screw them in all the way.
NOTE: | The | holes | in the Trap | are not | threaded but the | |
screws | are | "Thread | Cutting | Screws" | and will cut a | |
thread | as | they | are | tightened. |
|
|
R. Find four Flat Head Machine Screws
9.Attach the Disc Dos1 Trap with four flat head screws
10.There is a flat spot on the shaft near the end. Rotate the shaft so that the flat spot is facing up.
11 Place the disc on the shaft so that the set screw ts facmc up. Position the disc so that it is approx, 1/16 rich outward from the edge of the dust trap.
12 Insert the long end of me 532" setscrew wrench through me hole in the disc housmg and mto the
setscrew n the disc. Make sure setscrew _s aligned with "F ]at" on shaft.
NOTE: After several hours of operation, check for ooseness of setscrew and ret_gh[er
13.Make certain that the metal disc is free of oil and grease then peel the backing from the 9" abrasive disc and affix to the sanding disc.
DISC DUST TRAP
FLAT HEAD SCREWS
1 3/4" LONG
FLAT SPOT
/ONSHAFT
/
/
/
/ / /
5/32INCH
/WRENCH
TRAP
\ \
\
10
