maintenance
WARNING: FOR YOUR OWN SAFETY, TURN SWTCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE ADJUST-
ING, MAINTAINING, OR LUBRICATING YOUR FINISHING MACHINE.
Keep your machine and your workshop clean. The dust traos around the abrasive disc and the abrasive belt are
designed to deflect most of the fine dust. They should be connected to a Mac for most efficient dust removal
WARNING: DO NOT ATI'ACH AVACWHEN FINISHING
IRON DR STEEL. THE SPARKS COULD IGNITE THE
DEBRIS AND CAUSE A FIRE,
(f power cord ts worn or cut, or eamaged in any way have _treplaced immediately.
Frequently blow oat any dust that may accumulate inside the moto_
A coat of
Do not apply wax to the abrasive belt table because the belt could Dick uD the wax and deposit it on the pulleys,
causing the'belt to sli_.
MOTOR MAINTENANCE AND
LUBRICATION
1 The bearings, in both end stllelds Of the motor, have been
lubricated at the factory with correct lubricant No other part of the motor reautres lubrtcabon
2
instructions ontne nameplate Be sure to wipe off dirt or grit if present around od hole capsto prevent anypossibd_ty
of foreign material eontaminapng the oil wicks that supply the bearings with oil Use a good grade of rrled{um weight mineral ell. SUCh as automobde engine oil, SAE 20.
3 If disassembl_ of [ne motor is necessary, it should be returned to your nearest Sears retad or mall order store {n order to prevent vo=dtng the guarantee
NOTE: The s[_eea of thts motor cannot be regulated or changed
4.Ever. effort should De made to prevent fore=gn material from entering me motor. When operated under conddlons
_KetVtO Dermtt accumulatlor3s of (Just, dirt, or waste wdh_ n the motor a visual insDection should be made at frequent
mterva=s Accumulations of dr,/dust can usually be blown out successful[,.
NOTE: Motors usedon
Suscepttble TOthe accumulatton of sawdust and wood ch=ps
and should be blown out or "vacuumed" frequently to
prevent nterference WITh normal motor ventilabon and
proper ouerat=on ot the
SWlta[1,
lubrication
The BEARINGS in this machine are packed with grease at the factory. They requtre no further lubrication.
Periodically lubrlcate the cams and shafts in the idler pulley mechanism with Silicon Spray.
SEARS RECOMMENDS | THE |
FOLLOWING ACCESSORIES | |
ITEM | CAT. NO. |
Steel Stand | |
Caster Set | |
Miter Gauge | |
Pressure*Sensitive cement | |
Abrasive Belts and Disc | SEE CATALOG |
Steel Legs | |
Power Tool Know How Handbooks |
|
Radial Saw | |
Table Saw | |
Sears may recommend other accessories not listed in the manual, See your nearest Sears store or catalog department for other accessories. Do not use any accessory unless you have received and read complete instructions for its use.
i i¸
_'i " i i_ ,ii i_i_
22
