Cyclades AlterPath BladeManager user manual Updating the Server Configuration

Updating the Server Configuration

Updating the Server Configuration

When you start the BladeManager for the first time after you add or remove an internal option or external SCSI device, you might receive a message that the configuration has changed. The Configuration/Setup Utility program starts automatically so that you can save the new configuration settings.

Some options have device drivers that you need to install. See the documentation that comes with the device information about installing any required device drivers.

If the server has a RAID configuration using the SCSI controller with integrated RAID (SCSI models only) or the integrated Serial ATA controller with RAID and you have installed or removed a hard drive, you might have to reconfigure your disk arrays. See the RAID documentation on the IBM ServeRAID-7e (Adaptec HostRAID) Support CD for more information about reconfiguring the disk arrays.

If the server has an optional RAID adapter and you have installed or removed a hard disk drive, see the documentation that comes with the RAID adapter for information about reconfiguring the disk arrays.

BladeManager Controls, LEDs, and Power

This section describes the controls and light-emitting diodes (LEDs) and how to switch the BladeManager on and off.

Front View

The diagram below shows the controls and LEDs on the front of the

BladeManager.

AlterPath BladeManager Manual 2-23