Cyclades AlterPath BladeManager user manual First Time Configuration Wizard An Example

4: BladeManager Web Administration

Are you sure you wish to continue? (Y/N) y

Restoring default configuration ... done.

The new configuration will take effect after the next boot. [root@BladeManager root]# reboot

Refer to the sample First Time Configuration, next section, to view how the parameters are entered into the system.

4.Save and reboot.

Once saved, the BladeManager applies the new configuration to the system and saves the information on a Compact Flash card.

First Time Configuration Wizard: An Example

The First Time Configuration sample session shown below shows the portion of the command line data where the user configuration begins. This is commenced by the heading, Welcome to Cyclades-APBM!

Caution: Before the Welcome heading appears, the system will prompt you for the following:

Do you want to re-create hard disk partitions? (y/n) [n] Do you want to re-create the System file system?(y/n)[n]

Do you want to re-create the Console Log file system?(y/n)[n] Do you want to re-create the Configuration file system?(y/n) [n]

Be sure to answer no to the above questions. Once completed, you should see the configuration text as shown in the example below.

Note: Default values are enclosed in angled brackets after each question or prompt. Press <Enter> to accept the default value.

=====================================================

Welcome to Cyclades-APBM!

Since this is the first time you are booting your APBM, you need to answer some basic configuration questions. Once this is done, the other APBM configuration parameters can be set through its Web Management Interface (WMI).

Press any key to continue.

4-6 AlterPath BladeManager Manual