Cypress CY7C68015A, CY7C68016A, CY7C68014A manual CY7C68013A/15A Pin Descriptions

CY7C68013A, CY7C68014A

CY7C68015A, CY7C68016A

4.1CY7C68013A/15A Pin Descriptions

The FX2LP Pin Descriptions follows.[10]

Table 11. FX2LP Pin Descriptions

128	100	56	56	56 VF-	Name	Type	Default	Description
TQFP	TQFP	SSOP	QFN	BGA
10	9	10	3	2D	AVCC	Power	N/A	Analog VCC. Connect this pin to 3.3V power source.
								This signal provides power to the analog section of the
								chip.
17	16	14	7	1D	AVCC	Power	N/A	Analog VCC. Connect this pin to 3.3V power source.
								This signal provides power to the analog section of the
								chip.
13	12	13	6	2F	AGND	Ground	N/A	Analog Ground. Connect to ground with as short a path
								as possible.
20	19	17	10	1F	AGND	Ground	N/A	Analog Ground. Connect to ground with as short a path
								as possible.
19	18	16	9	1E	DMINUS	IO/Z	Z	USB D– Signal. Connect to the USB D– signal.
18	17	15	8	2E	DPLUS	IO/Z	Z	USB D+ Signal. Connect to the USB D+ signal.
94					A0	Output	L	8051 Address Bus. This bus is driven at all times.
								When the 8051 is addressing internal RAM it reflects
95					A1	Output	L
								the internal address.
96					A2	Output	L
97					A3	Output	L
117					A4	Output	L
118					A5	Output	L
119					A6	Output	L
120					A7	Output	L
126					A8	Output	L
127					A9	Output	L
128					A10	Output	L
21					A11	Output	L
22					A12	Output	L
23					A13	Output	L
24					A14	Output	L
25					A15	Output	L
59					D0	IO/Z	Z	8051 Data Bus. This bidirectional bus is high
								impedance when inactive, input for bus reads, and
60					D1	IO/Z	Z
								output for bus writes. The data bus is used for external
61					D2	IO/Z	Z
								8051 program and data memory. The data bus is active
62					D3	IO/Z	Z	only for external bus accesses, and is driven LOW in
								suspend.
63					D4	IO/Z	Z
86					D5	IO/Z	Z
87					D6	IO/Z	Z
88					D7	IO/Z	Z
39					PSEN#	Output	H	Program Store Enable. This active-LOW signal
								indicates an 8051 code fetch from external memory. It
								is active for program memory fetches from
								0x4000–0xFFFF when the EA pin is LOW, or from
								0x0000–0xFFFF when the EA pin is HIGH.
Note

10.Unused inputs must not be left floating. Tie either HIGH or LOW as appropriate. Outputs should only be pulled up or down to ensure signals at power up and in standby. Note also that no pins should be driven while the device is powered down.

Document #: 38-08032 Rev. *L Page 21 of 62

[+] Feedback