CY8C24123A
CY8C24223A, CY8C24423A
Document Number: 38-12028 Rev. *I Page 38 of 56
When bypassed by a capacitor on P2[4], the noise of the analog ground signal distributed to each block is reduced by a factor of up
to 5 (14 dB). This is at frequencies above the corner frequency defined by the on-chip 8.1k resistance and the external capacitor.
Figure 20. Typical AGND Noise with P2[4] Bypass
At low frequencies, the opamp noise is proportional to 1/f, power independent, and determined by device geometry. At high
frequencies, increased power level reduces the noise spectrum level.
Figure 21. Typical Opamp Noise
100
1000
10000
0.001 0.01 0.1 1 10 100Freq ( kHz)
dBV/rtHz
00.010.11.010
10
100
1000
10000
0.001 0.01 0.1 1 10 100
Freq (kHz)
nV/rtHz
PH_BH
PH_BL
PM_BL
PL_BL
[+] Feedback