D-Link DVG-6008S guide

17

Listen Port UDP: It is not necessary to change the protocol of the communication port used by the gateway.

RTP Starting Port UDP: The initial value of port number for transmitting voice data among Gateway(s). Each line requires 2 ports (RTP/RTCP). It is not necessary to change these.

For example: If the starting port is 9000, then Line 1 is using 9000(RTP) and 9001(RTCP),

Image 19

D-Link DVG-6008S user manual

Contents

DVG-6008S Voip Gateway Page Contents IP Sharing Functions Coding Principle Advanced Feature Product Overview Introduction Hardware Description Front Panel DVG-6008S Model Rear Panel Gateway Assigned with a Public IP Address Network InterfaceGateway in a NAT network Page Integrating Line Ports with PBX Telephone Interface Description Preparation Basic Settings of a GatewayIVR Interactive Voice Response To inquire about current Gateway’s WAN Port IP address Save SettingsSoftware Upgrades Instructions IVR Functions Table Function Code Description Example Function Code Description Example Default Gateway Settings Static IP Settings Function Command Select a Static IPIP address Settings Subnet Mask Settings Select a PPPoE Adsl PPPoE SettingsPPPoE Account Settings Recorded Voice File PPPoE Character Conversion Table Instructions Network Settings WANPage Adsl PPPoE Settings IP Configuration Setting WAN PortSetting Dynamic IP Dhcp Setting Static IP BigPond for Australia use only DNS SettingsClone MAC Using Phone Books Manager LAN interface mode※ Network Settings LANLAN IP/Subnet mask Dhcp Settings WAN QoS QoS SettingsLAN QoS※ NAT Traversal NAT/DDNS Ddns For example Telephony SettingsPrefix Number Rules Example Hotline Functions Example Description SIP 164 System Each line registers to Proxy independently FXO Representative number registers to Proxy Calling Features Advanced Options Line Settings Codec Fax SettingsPage Digit Map Speed Dial Phone Book Caller Filter CDR SettingsACL for Management Transit Call Control Language Long Distance Exception Table Long-Distance Control Table CPT parameters Table CPT/Cadence SettingsBusy Tone Cadence Measurement UDT Detection Detailed description is given below Direct Connection to Pstn Connected to a PBX Extension Line Page Filling in the CPT Table Save Settings System Information Stun Inquiry RTP Packet SummaryPing Test Snmp Backup/Restore System Operations Save Settings Provision Settings Logout Software Upgrade IP Sharing Functions Select TCP/IP, and then click Properties Page Dialed Number Processing Flow Instruction End RIPRouting Information Protocol ※ Static Route※ IP Filtering Port filtering Virtual Server MAC Filtering Special Applications※ URL Filter※ DoS Prevention Settings※