Telephony Settings, Prefix Number Rules, Example | D-Link DVG-6008S

These settings are only necessary when the gateway is set up under a NAT that uses a dynamic IP address and do not support DDNS.

Choose a DDNS Server: The current system allows users to choose either DynDNS、TZO、3322.org、 PeanutHull or a private server. Please apply for a user account before choosing a service provider.

Server address: Sets up the IP address or URL (Uniform Resource Locator) of the DDNS Server.

Hostname: The URL of the system (or NAT) – apply from a domain name registration providers.

Login ID and Password: The ID and password are used to log into the DDNS server.

Behind NAT: Select only when the system is set up under NAT.

Note: If the Gateway is set up under NAT, then enter the hostname into the NAT IP/Domain that is the same with Hostname of DDNS.

Example:

NAT

DDNS

Telephony Settings

Prefix Number Rules

Trunk Dial Out Verify/ Trunk Dial Out Replace: VoIP gateway will check (verify) the dial out prefix from dial out numbers and change (replace) the prefix to transit out through FXO port.

For example:

If you transit out with 01907123456, the system will trans to 190601 907123456. If you transit out with 008621123456 the system will replace it with 190200 8621123456.

Trunk Dial Out Deny: The system will deny the call with the leading number filled in this column.

Image 28

D-Link DVG-6008S user manual Telephony Settings, Prefix Number Rules, Example, For example

Contents

DVG-6008S Voip Gateway Page Contents Advanced Feature IP Sharing Functions Coding Principle Introduction Product Overview Hardware Description Front Panel Rear Panel DVG-6008S Model Gateway Assigned with a Public IP Address Network InterfaceGateway in a NAT network Page Telephone Interface Description Integrating Line Ports with PBX Preparation Basic Settings of a GatewayIVR Interactive Voice Response Save Settings Software UpgradesInstructions To inquire about current Gateway’s WAN Port IP address IVR Functions Table Function Code Description Example Function Code Description Example Static IP Settings Function Command Select a Static IP IP address SettingsSubnet Mask Settings Default Gateway Settings Adsl PPPoE Settings PPPoE Account SettingsRecorded Voice File Select a PPPoE PPPoE Character Conversion Table Network Settings WAN InstructionsPage IP Configuration Setting WAN Port Setting Dynamic IP DhcpSetting Static IP Adsl PPPoE Settings BigPond for Australia use only DNS SettingsClone MAC Using Phone Books Manager LAN interface mode※ Network Settings LANLAN IP/Subnet mask Dhcp Settings WAN QoS QoS SettingsLAN QoS※ NAT/DDNS NAT Traversal Ddns Telephony Settings Prefix Number RulesExample For example Hotline Functions Example Description SIP 164 System FXO Representative number registers to Proxy Each line registers to Proxy independently Calling Features Advanced Options Line Settings Fax Settings CodecPage Digit Map Phone Book Speed Dial Caller Filter CDR SettingsACL for Management Language Transit Call Control Long-Distance Control Table Long Distance Exception Table CPT/Cadence Settings Busy Tone Cadence MeasurementUDT Detection CPT parameters Table Detailed description is given below Direct Connection to Pstn Connected to a PBX Extension Line Page Save Settings Filling in the CPT Table System Information Stun Inquiry RTP Packet SummaryPing Test Backup/Restore Snmp Provision Settings System Operations Save Settings Software Upgrade Logout IP Sharing Functions Select TCP/IP, and then click Properties Page Instruction Dialed Number Processing Flow End Static Route※ RIPRouting Information Protocol ※ Port filtering IP Filtering MAC Filtering Virtual Server URL Filter※ Special Applications※ DoS Prevention Settings※