System | D-Link DVG-6008S guide

Enable Support of SIP Proxy Server / Soft Switch: Enable the functions to inter-work with Proxy Server / Soft Switch. When SIP Proxy 1 and 2 are enabled, the system will register to SIP Proxy 2 after all lines are failed to register to SIP Proxy 1. SIP Proxy 2 is a backup

system.

Proxy Server IP/Domain: Enter the Proxy Server IP address or URL (Uniform Resource Locator). You can set 3 redundant Proxy spread by semicolon.

EX: 61.123.231.1;12.34.56.78;proxy.sip.sip

Proxy Server Port: Enter the Proxy Server listen port number. (The factory default value is 5060)

Proxy Server Realm: Enter the correct registered Proxy Server Realm name to avoid registration failure. If you fail to make a call, please contact your ITSP.

TTL: Enter the desired time interval at which the gateway will report to you Proxy Server.

SIP Domain/Use Domain to Register: Enter the correct SIP domain to avoid registration failure (it is not necessary to set with some Proxy Servers). If you enable “Uses Domain to Register” the gateway will register to Proxy with the domain name you filed. Else, the gateway will register to a Proxy with the IP it resolves. If you fail to make a call, please contact your ITSP.

Bind Proxy Interval for NAT: This function is able to keep the binding is existed when the gateway is behind NAT and SIP Proxy is not able to keep the binding.

Initial Unregister: After rebooting, it is unregistered first and then do the general registry process.

Image 34

D-Link DVG-6008S user manual System

Contents

DVG-6008S Voip Gateway Page Contents Advanced Feature IP Sharing Functions Coding Principle Introduction Product Overview Hardware Description Front Panel Rear Panel DVG-6008S Model Gateway Assigned with a Public IP Address Network InterfaceGateway in a NAT network Page Telephone Interface Description Integrating Line Ports with PBX Preparation Basic Settings of a GatewayIVR Interactive Voice Response Instructions Save SettingsSoftware Upgrades To inquire about current Gateway’s WAN Port IP address IVR Functions Table Function Code Description Example Function Code Description Example Subnet Mask Settings Static IP Settings Function Command Select a Static IPIP address Settings Default Gateway Settings Recorded Voice File Adsl PPPoE SettingsPPPoE Account Settings Select a PPPoE PPPoE Character Conversion Table Network Settings WAN InstructionsPage Setting Static IP IP Configuration Setting WAN PortSetting Dynamic IP Dhcp Adsl PPPoE Settings BigPond for Australia use only DNS SettingsClone MAC Using Phone Books Manager LAN interface mode※ Network Settings LANLAN IP/Subnet mask Dhcp Settings WAN QoS QoS SettingsLAN QoS※ NAT/DDNS NAT Traversal Ddns Example Telephony SettingsPrefix Number Rules For example Hotline Functions Example Description SIP 164 System FXO Representative number registers to Proxy Each line registers to Proxy independently Calling Features Advanced Options Line Settings Fax Settings CodecPage Digit Map Phone Book Speed Dial Caller Filter CDR SettingsACL for Management Language Transit Call Control Long-Distance Control Table Long Distance Exception Table UDT Detection CPT/Cadence SettingsBusy Tone Cadence Measurement CPT parameters Table Detailed description is given below Direct Connection to Pstn Connected to a PBX Extension Line Page Save Settings Filling in the CPT Table System Information Stun Inquiry RTP Packet SummaryPing Test Backup/Restore Snmp Provision Settings System Operations Save Settings Software Upgrade Logout IP Sharing Functions Select TCP/IP, and then click Properties Page Instruction Dialed Number Processing Flow End Static Route※ RIPRouting Information Protocol ※ Port filtering IP Filtering MAC Filtering Virtual Server URL Filter※ Special Applications※ DoS Prevention Settings※