Daewoo DRVT-40, DRVT-43 Connectionsti, Connecting a TV, Connecting Antenna/Cable, RF Connection

DTBC-MNF(or D)1NP-AG 2007.9.20 2:57 PM ˘ ` 17

Connectionsti

To enable you to set up your new DVB-T VCR/DVD recorder, it must be connected it to your TV using either a SCART cable or a COMPONENT (or S-Video) and associated AUDIO cable. If a unit has HDMI connection, you can use a HDMI cable as well.

INTRODUCTION

•There are a variety of ways to connect the DVB-T VCR/DVD Recorder to your TV and other equipment. Use only one of the connections described below. Whichever TV connection you use will work with all input sources.

•Please refer to the manuals for your TV, VCR, stereo system, or other devices as necessary to make the best connections.

•For better sound reproduction, connect the DVB-T VCR/DVD Recorder’s AUDIO OUT jacks to the audio in jacks of your amplifier, receiver, stereo, or audio/video equipment. See ‘Connecting an Amplifier/Receiver‘ on page 19.

Connecting a TV

Choose one of the following TV connections, depending on the capabilities of your equipment.

Rear of TV

ANTENNA

INPUT

Pr Pb Y

CONNECTIONS

Caution

•Make sure the DVB-T VCR/DVD Recorder is connected directly to the TV, and the TV is set to the correct video input.

•Do not connect the DVB-T VCR/DVD Recorder’s AUDIO OUT jack to the phone in jack (record deck) of your audio system.

•Do not connect the unit through a VCR. Video signals fed through VCRs may be affected by copyright protection systems and the picture will be distorted on the television.

Connecting Antenna/Cable

1Disconnect the antenna/cable from the rear of your TV.

2Connect this cable to the jack marked ANT IN (FROM ANT.) on the rear panel of the DVB-T VCR/DVD Recorder.

Antenna Antenna

Rear of DVB-T VCR/DVD Recorder

RF Connection

Connect the ANT OUT (TO TV) jack on the DVB-T VCR/DVD Recorder to the antenna in jack on your TV using the supplied 75-ohm RF cable (R).

This set doesn’t have a modulator output. However it still supplies the RF loopthrough Output.

Scart Connection

1 Plug a scart cable into the scart socket TV

(EURO AV1) at the back of the DVB-T VCR/DVD

Recorder and the corresponding scart socket at

the back of the TV set. (V)

Flat Wire (300ohm)

Cable TV Wall Jack

2 Plug a scart cable into the top scart socket

VCR/DVD (EURO AV2/DECODER) at the back of

the DVB-T VCR/DVD Recorder and the

300/75ohm Adapter	OR	OR
(Not supplied)

corresponding scart socket at the back of the

Decoder.

Rear of DVB-T VCR/DVD Recorder

17