Connections
S-Video Connection
1Connect the
2Connect the Left and Right AUDIO OUT jacks from the
Component Video Connection
•If your television is a
•If your TV does not accept the Progressive Scan format, the picture will appear scrambled.
1Connect the COMPONENT VIDEO OUT jacks on the
2Connect the Left and Right AUDIO OUT jacks of the
• When you use component video connection, you can change the resolution (576i, 576p) for the component output by setting the video output option in the setup menu (See page 31).
-Interlaced mode : 576i
-Progressive mode : 576p
•When you use the HDMI connection, the audio’s sampling frequency is outputted only with 48KHz even if you select [96KHz].
•This recorder does not perform internal (2 channel) decoding of a DTS sound track. To enjoy DTS multi channel surround sound, you must connect this recorder to a DTS compatible receiver via one of this recorder’s digital audio outputs.
•No sound will be output from the HDMI cable if the Digital out option is not set to ‘PCM’ on the Setup menu (See page 31).
•The arrow on the cable connector body should face up for correct alignment with the connector on the recorder.
•If there is noise or lines on the screen, please check the HDMI cable.
•When you use HDMI connection, you can change the resolution (576i, 576p, 720p, 1080i) for the HDMI output by setting the video output option in the setup menu (See page 31).
-RGB : 576i
-Interlaced mode : 576i, 1080i
-Progressive mode : 576p, 720p
•Changing the Progressive Scan mode when the recorder is connected with HDMI connector may result in malfunctions. To solve the problem, turn off the recorder and then turn it on again.
•Progressive Scan does not work with the RF, Audio/Video or
HDMI connection
If you have a HDMI TV or monitor, you can connect it to this recorder using a HDMI cable.
1Connect the HDMI jack on the recorder to the HDMI jack on a HDMI compatible TV or monitor
(H).
2Set the TV’s source to HDMI (refer to TV’s Owner’s manual).
18
