Datalogic Scanning 6000 PLUS manual Low Power Mode, Disable LOW Power Idle

Low Power Mode

QuickScan 6000/6000 Plus incorporates two optional low power modes to optimize power usage and extend scanner life.

NOTE

These features are only available with RS-232, Wand Emulation and Keyboard Wedge host interfaces.

WARNING

DO NOT use Very Low Power Mode in conjunction with Stand Mode, as this feature is not compatible and may cause unexpected behavior.

Low Power Idle — places the scanner's microcontroller into a WAIT state during idle periods. Any interrupt will bring the scanner to life, including internal timer and watchdog events.

Very Low Power Mode (RS-232 and Wand Emulation interfaces ONLY1) — places the scanner in a STOP state during idle periods. The scanner can only be brought out of its STOP state by a trigger pull or hardware reset.

SET

LOW POWER MODE

----------------------------------------------

DISABLE -----------------------------

LOW POWER IDLE ------------------

VERY LOW POWER MODE1 ---------------

END ----------------------------------------------

1Very Low Power Mode can be used with RS-232 and Wand Emulation Interfaces ONLY . If Very Low Power Mode is selected with other interfaces will cause the scanner to default to Low Power Idle instead.

Programming Guide 85