Software Control
XON/XOFF — this is software handshaking that allows the host to control data transmission. If the host sends an XOFF command to the scanner, the scanner will not send the bar code data until it receives an XON command from the host. If the host sends the XOFF command during data transmission, the host will receive additional characters for no more than 2msec1.
NOTE
Hardware/software controls are mutually exclusive. Enable only one of these features at a time, as enabling multiple controls can produce unpredictable results.
SET ----------------------------------------------
SOFTWRE CONTROL HARDWARE CONTROL
DISABLE HARDWARE CONTROL
ENABLE CTS/RTS FLOW CONTROL
ENABLE CTS SCAN CONTROL
ENABLE XON/ XOFF ----------------
DISABLE XON/XOFF ----------------
END ----------------------------------------------
1 Varies slightly depending upon baud rate selected.
20 | QuickScan 6000/6000 Plus |
